Metal Rugged Indoor Use All-in-One RFID 125 KHz Card + PIN Access Control w PIN LED
The appearance of new products , elegant. Zinc alloy shell , with noble blue luminous function .
Introduction :
The appearance of new products , elegant. Zinc alloy shell , with noble blue luminous function . Non-contact proximity card access controller access control system is one of modern art . It uses the latest central processing unit (CPU) And large capacity non-volatile memory chips, all the information will not be lost due to power ; usingHOMMARDThe latest technology, powerful, with proximity card to open the door , induction card and password , card or password to open the door three kinds of ways to open the door .
This product has a door alarm and status output Tamper alarm ( warning : Alarm current maximum150mA) , Sensors and other sound card with password security measures allow users more secure ; open button , closing reminders, can be connected to electric power lock lock lock lock or other powerful features , allowing users to more easily select .
This product provides a secure way to automatically export controls is a business organization office factories and other places ideal residential unit .
SB-K02Can achieve1000A card user and each card can be set up a group of users4Digit password , relay output can provide3Amp load capacity.
Two, Features
Programmable functions
*Open delay time ;
* 1An administrator,Password can be set and modified,Managed1000A card user and password for the user ;
*Door status monitoring .
Programmable time
*Opening hours: 00~99Sec ;
*Alarm time:00~99Minutes.
Tips:
Please executed once before the first use"Restore to factory settings".
Do not attempt to repairSB-K02Controller. If there are questions, please communicate with manufacturers solving, communication can not be resolved , please go back to factory repair .
Before installation , for use in drilling in the wall , carefully inspect the dark wire or tube , or fixed in the borehole when the clip you want to use safety glasses .
Third, the interface principle and interface parameters
1. Alarm output interface
Alarm output is an open collector output, maximum output current tankprefix = st1 ns = "urn: schemas-microsoft-com: office: smarttags"150 mA, Interface schematics as ( Figure1) .
2. Relay Output Interface
SB-K02The relay output is fully isolated with its internal circuit output , contact output load capacity of3AInterface principle as ( Figure2) .
Chart1Â Alarm output interface Chart2Â Relay Output Interface
Four , installation, fixing and wiring
1. Lay the mounting holes in the wall or installed wiring box .
2. The lead from the bottom of the outlet hole piercing, unplug the wire caps, connect the required
The lead line ( refer to Figure5-1Or Fig.5-2) .
3.Please do not wire wrapped with insulating plastic .
4. The Division is equipped with a screw fixed to the bottom or wall wiring box(Chart3 ).
5. Plug into the wiringPCBTerminal Block board(J1)(Figure4) .
6. Then finished line, and finally with screw locking surface shell and bottom ( Figure3) .Â
SKU | KL1K |
---|---|
Weight | 1.000000 |
With Built-in Battery | No |
Still have a question? No worries.