46 LED Solar Power SMD 2835 Light Sensor PIR Motion Sensor LED Solar Light Waterproof Outdoor LED Ga

Feature:
-This product is an energy-saving solar energy product that can be installed conveniently
-Widely used in the courtyard,trails,gardens and some place where are inconvenient to connect electricity for illumination
-Easy installation:fixed installation.There is no need to install any wiring or other complicated installation procedures.
-Using solar energy charging system,light controller and body induction controller.Therefore,the electric circuit is off in daytime,and when people is nearby at night,it will light without any need of manual control
-Energy saving,if there is no one in the induction zone,the light will turn into dim.

Specification:
Shell material:plastic
Solar panel:5V 2.5W
Battery:Lithium battery 3.2v 3000mah
Max voltage:3.65V
Min voltage:2.65V
LED quantity:46pcs
Max power:6W
Working current:30-1600mA
Luminous flux:800lm
Color:Black
LED type:SMD 2835 29-30LM 6000k
Detection angle:120°
Detection distance:4-8 meters
Waterproof:IP65
Size:203*97*80mm

Application Methods:
First,completely shut out the solar panels or put it down on the desktop.Then press the button for 5 seconds to start the lamp.Enter the first operating mode after starting.Each press of the button will change the operation modes with the lights flickering at the same time.The circulatory switchover of operating modes is as follows:
1.Micro-mode+induction mode
When someone comes,the sensor triggers circuit to start high light;the light will dim after someone leaving for 15 seconds
(Firstly recommended to use)
2.Induction mode
When someone comes,the sensor triggers criggers circuit to start high light;the light will be turnned off after someone leaving for 15 seconds
(Use in the places with short lighting time)
3.Always light mode
It will always light at night with no induction function
(Used in special places)
4.Emergency light mode
Commonly use for emergency lighting,such as power failure and night activities.The timing of emergency light mode is 30 minutes.The solar panels should be restarted or illuminated after the lights off.
5.Shutdown

Package included:
1 × LED Solar Motion Sensor Light
2 × Screw
2 × Pillar Hinge
1 × User Manual